4-10 Configuring Your Server
The items which can be set on the Main menu screen and their functions are described below.
Option Parameter Description Your Setting
System Time HH:MM:SS Sets the system time.
System Date MM/DD/YYYY Sets the system date.
Legacy Diskette A Disabled
360Kb 5
1
/
4
1.2MB 5
1
/
4
720Kb 3
1
/
2
[1.44/1.25MB
3
1
/
2
]
2.88MB 3
1
/
2
Sets the settings of the
factory-installed floppy disk drive.
Legacy Diskette B [Disabled]
360Kb 5
1
/
4
1.2MB 5
1
/
4
720Kb 3
1
/
2
1.44/1.25MB 3
1
/
2
2.88MB 3
1
/
2
No second floppy disk drive is
included in this system.
Hard Disk Pre-Delay [Disabled]
3 seconds
6 seconds
9 seconds
12 seconds
15 seconds
21 seconds
30 seconds
Allows slower spin-up drives to come
ready.
Primary IDE Master/
Primary IDE Slave
IDE Secondary/Master
IDE Secondary/Slave
Select submenu Sets the information on the device
connected to each channel on the
submenu. The settings of some items
may be changed. However, leave the
items as they are at the shipment.
Serial ATA Channel 0
Master
Select submenu Sets the information on the device
connected to each channel on the
submenu.
Serial ATA Channel 1
Master
Select submenu Sets the information on the device
connected to each channel on the
submenu.
Advanced Processor
Options
Select submenu Shows the processor settings
submenu.
Language [English (US)]
Français
Deutsch
Español
Italiano
Selects in which language the BIOS
is displayed.
[ ]: Factory-set
IMPORTANT: Check and adjust the system clock before the operation if any of the
following conditions is applicable.
îš„ After carriage of device
îš„ After storage of device
îš„ After the device is entered into the pause state under the environmental condition
enduring device operation (temperature: 10°C - 35°C, humidity: 20% - 80%)
Check the system clock at the rough rate of once per month. When the system clock is
installed in a system requiring high time precision, it is recommended to use a time server
(NTP server).
If the system clock is remarkably delayed or advanced in spite of adjustment, contact your
service representative for maintenance.
To Next Page
Loading...
Need help?
General
