4-20 Configuring Your Server
Server
The Server menu appears if you move the cursor to "Server."
Selecting an item on the screen allows the proper submenu to appear.
See the table below for the items.
Option Parameter Description Your Setting
Assert NMI on
SERR
Disabled
[Enabled]
Indicates whether PCI SERR is
supported or not.
Post Error Pause Disabled
[Enabled]
Indicates whether POST is aborted
once at the end of POST if an error
occurs during the execution of POST.
AC-LINK Stay Off
[Last State]
Power On
Specify the state of power when the AC
power to the server is turned off once
and then on. (See the table below.)
Power on Delay
Time
[0] - 255 Specify the DC power on delay time
within the range between 0 and 255
seconds. The time specified is valid
when "Power On" or "Last State" is
specified for AC LINK.
BMC IRQ* Disabled
[11]
Set the IRQ for BMC.
FRB-2 Policy* Disable FRB2
Timer
[Retry 3 Times]
Set the FRB level 2 timer.
Boot Monitor* [Disabled]
Every 5 minutes
between 5
minutes and 60
minutes
Specify whether to enable or disable the
boot monitoring function on booting, or
select the time limit for timeout.
To use this function, install ESMPRO
Agent. Set this item to "Disabled" if the
system is booted from OS without
installation of ESMPRO Agent.
To Next Page
Loading...
