Configuring Your Server 4-31
6. Press F2 during POST to run the BIOS Setup utility, and configure the mother board again.
IMPORTANT: If the SATA hard disk drives are installed in your server and the onboard
SATA RAID feature is used, change the parameter of the [SATA RAID Enabled] in the
[Advanced] - [I/O Device Configuration] menu from [Disabled] to [Enabled] before exiting
BIOS Setup. Leaving this parameter as the factory-set value (Disabled) may destroy the
data in hard disk drive.
NOTE: To display the [SATA RAID Enabled] menu, select [Advanced] - [I/O Device
Configuration] - [SATA Controller Mode Option] - [Enhanced].
To Next Page
Loading...
