Newtec M6100 - 10.11 Alarm Handling

Newtec Proprietary
Confidentiality: Unrestricted
V1.4
100/225
General Device Settings and Actions M6100 Broadcast Satellite Modulator
10.11 Alarm Handling
Alarm handling allows you to configure and manage the behavior of the different alarms in the
device.
Meaning that it is possible to
• mask (hide) alarms;
• assign alarms to a general interface or general device alarm.
Navigate to the following location to perform alarm handling.
M6100 >> Device Setup >Alarm Handling
List of Alarms
For a comprehensive list of alarms, refer to AppendixA-AlarmListonpage210
This function is available via the GUI, CLI and SNMP but not through the front panel: