Newtec M6100 - 8.2 Set Date and Time

Newtec Proprietary
Confidentiality: Unrestricted
V1.4
28/225
Getting Started M6100 Broadcast Satellite Modulator
Make sure that the management PC has access to this IP address or it belongs to this
IP range.
If needed it is possible to configure the Mgmt Gateway.
To configure the Mgmt Gateway
» Navigate to Mgmt Itf;
» Navigate to Gateway;
» Enter the correct Gateway address;
» Click OK.
Now it is possible to access the device from a management PC.
8.2 Set Date and Time
It is advised to set the device date and time according to your time zone.
» Select Device from the corresponding soft button;
» Navigate to Date and Time;
» Press OK (to unfold the branch);
» Navigate to Date or Time and press OK;
» Use the navigation down button to display numerical values;
» Use the Soft Buttons to enter a new Date or Time;
» Press OK to confirm the setting.