Newtec M6100 - Displayed Units; Get and Set Parameter Values

Newtec Proprietary
Confidentiality: Unrestricted
V1.4
69/225
How to Manage the Device M6100 Broadcast Satellite Modulator
9.7.10 Displayed Units
Some variables are by default scaled to a more readable unit.
For example:
• Symbol rate in Mbaud;
• Bit rate in Mbps;
• Frequencies in MHz.
When entering a new value (without specifying a scale) the default unit scaling is
applied.
For example:
[M6100] modulator# set outputfrequency=1550
OK
[M6100] modulator# outputfrequency get
1550 MHz
9.7.11 Get and Set Parameter Values
Use these commands to read out and set parameter values.
It is not mandatory to navigate to the specific branch to execute a command. It is
possible to request or set a value from the main branch.
When in a sub branch it is possible to get/set a value from another sub branch. Do
this by entering a prefix "/" to indicate that the navigation starts from the main branch.
Get
» Type the location and the parameter name to readout the requested parameter value.