Newtec M6100 - 5.2 Version History and Applicability

Newtec Proprietary
Confidentiality: Unrestricted
V1.4
12/225
About this Manual M6100 Broadcast Satellite Modulator
5.2 Version History and Applicability
Documen
t Version
Date Subject Comment
1.0 September 2013 M6100 Boadcast
Satellite
Modulator
• GUI update;
• Support of S2-Extensions;
• Switching between two
M6100devices with different BISS
SetupID is not possible;
• BBF over IP;
• DC-BUC Power on L-Band TX.
1.1 February 2014 M6100
Boadcast
Satellite
Modulator
• Remove BISS mode 0, 1 and E
not applicable for this release.
• Update MPE functionality
description in section 11.7.
1.2 April 2014 M6100
Boadcast
Satellite
Modulator
• Update Physical Description Back
Panel (section 7.2).
• Update ASI Output,
Signal Selection and Output
Selection depending on the
available ASI interfaces (four or
six) on the back panel of the
device
(section 11.5).
1.3 April 2014 M6100
Boadcast
Satellite
Modulator
• Added a note that it is not advised
to select low roll-off factors (20%
and lower) in DVB-S and
DVB-DSNG mode. (section
12.1.5)
1.4 August 2014 M6100
Boadcast
Satellite
Modulator
• Updated Traffic Classification,
Shaping and Channels (section
11.7.4)