Newtec Proprietary
Confidentiality: Unrestricted
V1.4
133/225
Data Interfaces M6100 Broadcast Satellite Modulator
M6100>TS over IP >> Monitor >> Source Info
This monitoring parameter provides the actual used input source IP Address and UDP port.
Source redundancy is only applicable for those remote devices sending to the same
multicast address and same UDP port.Thus, source redundancy cannot be used for
remote devices sending to a different multicast address or a different UDP port.
11.7 Multiprotocol Encapsulation
Multiprotocol Encapsulation is used to take in Ethernet data and insert it into a TS.
MPE is a data link layer protocol defined by DVB and published as: ETSI EN 301 192.
Note that ordering number VM-01 is required to activate this functionality.
Enable MPE on the following location:
To Next Page
Loading...
