Newtec M6100 - Input TS Bit Rate; Source Redundancy

Newtec Proprietary
Confidentiality: Unrestricted
V1.4
132/225
Data Interfaces M6100 Broadcast Satellite Modulator
11.6.9 Input TS Bit Rate
M6100 TS over IP >> Input TS Bit Rate
Define the input TS bit rate when the CBR traffic profile is selected.
With the rate adapter enabled, the output rate will be adjusted to match the Modulator symbol rate.
To enable the rate adapter refer toRateAdaptation.onpage164
When the inserted bit rate is too high/low the following alarm is generated: TS over IP Invalid TS
Bit Rate.
11.6.10 Source Redundancy
Source redundancy for TS over IP is a protection mechanism built into the modulator. This
mechanism takes care of the fact that the modulator only listens to one source at a time.
In other words, the modulator takes in the first detected TS stream for further processing. The other
stream (with the same UDP destination port) is ignored because the packets have a different source
address.
When for 300ms no data is received from the “active” source, the modulator switches over to the TS
stream delivered by the other source.
The source in this context is defined as an IP Address and a UDP port number.