Newtec Proprietary
Confidentiality: Unrestricted
V1.4
59/225
How to Manage the Device M6100 Broadcast Satellite Modulator
9.7 Command Line Interface (CLI)
This sections describes how the device can be managed using the CLI.
The commands and how they can be applied are described in the following sections.
9.7.1 How to Access the CLI
Access the CLI via an Ethernet management interface or via the craft interface by using a RS232
serial cable.
Management Interface
To access the CLI via the management interface do the following:
» Configure the IP Address of the management interface using the front panel.
Make sure that the IP address of the M6100 Boadcast Satellite Modulator is in the
same range as the IP Address of the managing device or that a default gateway is
configured.
» Make an Ethernet connection between the managing device and the M6100.
To Next Page
Loading...
