Newtec Proprietary
Confidentiality: Unrestricted
V1.4
78/225
General Device Settings and Actions M6100 Broadcast Satellite Modulator
10 General Device Settings and Actions
10.1 Access Control
Before implementing the device into a network it is recommended to consider which management
channels need to be enabled.
It is recommended to disable unused services to prevent unauthorized access to the
device. By default SNMP, CLI and FTP are enabled.
Login as expert user and navigate to the following locations to enable or disable these settings.
M6100 >> Device >> SNMP
M6100 >> Device >> CLI
M6100 >> Device >> FTP
M6100 >> Device >> Frontpanel
Once the frontpanel is put into read-only mode it can only be changed back to
read-write mode via one of the other available interfaces.
For example via the CLI interface using the craft interface.
(This is useful when the management IP address has changed and the device is
unreachable through IP connectivity).
To Next Page
Loading...
