Newtec Proprietary
Confidentiality: Unrestricted
V1.4
108/225
General Device Settings and Actions M6100 Broadcast Satellite Modulator
To Enable or Disable device redundancy go to the following location:
M6100 >> Device >> Redundancy
By default, device redundancy is disabled.
Initial Redundancy State:
• Standby (default value): This means when the device starts up and redundancy is enabled, the
initial state of the redundancy is standby. Typically:
– The modulator output is disabled;
– No IP Address on the data interface.
• Active.
To Next Page
Loading...
