Newtec M6100 - Page 121

Newtec Proprietary
Confidentiality: Unrestricted
V1.4
113/225
Data Interfaces M6100 Broadcast Satellite Modulator
Options Descriptions
Data1 or Data2 (Data) The bonding interface is active.
There is no preference in priority between the two available
interfaces.
Data1 before Data2 (Data) The bonding interface is active.
Interface Data1 has priority over interface Data2. This
means that when Data1 is available, this will be the active
interface.
Data2 before Data1 (Data) The bonding interface is active.
Interface Data2 has priority over interface Data1. This
means that when Data2 is available, this will be the active
interface.
Data1 (Non redundant) The bonding interface is not active!
Data1 is the active interface!
Data2 (Non redundant) The bonding interface is not active!
Data2 is the active interface!
To configure the bond interface, refer to section: DataIPConnectivityonpage110.
To have bonding working properly make sure to configure the switch/router in such a
way that the spanning tree is not blocking the fast switchover between ports.
In a typical Cisco switch configured using rapid spanning tree this is achieved by
setting the ports in PortFast mode.