Newtec M6100 - Page 155

Newtec Proprietary
Confidentiality: Unrestricted
V1.4
147/225
Data Interfaces M6100 Broadcast Satellite Modulator
BBF Stream
Configuration
Description
Name Enter a logical name.
Enable Enable the specified BBF endpoint.
IP Address
Type
Unicast:
Multicast:
Multicast IP
Address
Define to what multicast group the device belongs.
UDP Port Define on what UDP port the BBFs are received.
This is needed when the device belongs to a multicast group.
BBF Type Define the BBF type that is send by the source (AZ810) towards this
functional block.
Note: This option is inserted for future development when other BBF-Types
might become available.
Source
Redundancy
Enable in case of source redundancy.
The source ID is filtered and displayed in the monitoring info (Source Info).
When for 300ms no input is detected due to a failure of the source, the
redundant source is selected.
Note: Source redundancy is only applicable for those remote devices
sending to the same multicast address and same port.
Thus source redundancy cannot be used for remote devices sending to a
different multicast address or a different port.
Stream Monitoring