© 2011 Omnicell, Inc. 1-, 2-, 3-Cell Color Touch Installation and Service Guide/67-2014 Rev G
Frames and Wireways 2-1
Introduction
Frames and Wireways
Introduction
The 1-, 2-, 3-Cell OmniSupplier cabinet has a metal frame which houses the switchpanel control
boards (SPC boards) and many of the cables that connect the components of the system. The
frame is not field repairable and must be replaced if it is damaged. The wireway on the right side
of any cabinet in a 1-, 2-, or 3-cell OmniSupplier is removable and the SPC boards contained on
the wireways are also replaceable.
In the following procedure, references are made to removing specific modules such as the 9-
drawer carrier and the OmniDispenser. These portions of the procedure are not intended to show
how to completely remove a particular module, but to show the least amount of work that is
required to get the wireway free from the cabinet frame.
This chapter provides removal procedures. Installation can be done by performing the appropriate
removal procedure in reverse order.
Tools List
The following tools are required to perform the procedures in this chapter:
Tor x T8 driver
Torx T10 driver
Torx T15 driver
9/64” Allen wrench
Wireway Removal
CT PC Box Removal
1. Perform a graceful shutdown of the cabinet.
2. Unplug the cabinet power cord from the outlet.
3. Unlock the cabinet doors using the #2036 key.
4. Remove the screws that secures the CT PC Box to the cabinet.
To Next Page
Loading...