4-10 Switchpanels
Removal Procedure
1-, 2-, 3-Cell Color Touch Installation and Service Guide/67-2014 Rev G © 2011 Omnicell, Inc.
6. Remove the two screws on the back of the cath rack arm using a Torx T8 screwdriver.
Figure 4-17. Remove the two screws securing the LED cable to the cath rack arm
7. Slide the switchpanel toward the back of the unit. Stop when the switchpanel is about halfway
out.
8. Disconnect the switchpanel cable from the switchpanel.
Figure 4-18. Disconnect the switchpanel cable
To Next Page
Loading...