4-178
4-4 Communication Function
4
Functions
002Eh
ODc (analog O disconnection
detection)
R
1: ON
0: OFF
002Fh
OIDc (analog OI disconnection
detection)
R
1: ON
0: OFF
0030h
O2Dc (analog O2 disconnection
detection)
R
1: ON
0: OFF
0031h Not used
0032h FBV (PID FB status output) R
1: ON
0: OFF
0033h NDc (network error) R
1: ON
0: OFF
0034h LOG1 (logic operation output 1) R
1: ON
0: OFF
0035h LOG2 (logic operation output 2) R
1: ON
0: OFF
0036h LOG3 (logic operation output 3) R
1: ON
0: OFF
0037h LOG4 (logic operation output 4) R
1: ON
0: OFF
0038h LOG5 (logic operation output 5) R
1: ON
0: OFF
0039h LOG6 (logic operation output 6) R
1: ON
0: OFF
003Ah WAC (capacitor life warning signal) R
1: ON
0: OFF
003Bh WAF (cooling fan life warning signal) R
1: ON
0: OFF
003Ch FR (starting contact signal) R
1: ON
0: OFF
003Dh OHF (fin overheat warning) R
1: ON
0: OFF
003Eh LOC (light load detection signal) R
1: ON
0: OFF
003Fh MO1 (Drive Programming output 1) R/W
1: ON
0: OFF
0040h MO2 (Drive Programming output 2) R/W
1: ON
0: OFF
0041h MO3 (Drive Programming output 3) R/W
1: ON
0: OFF
0042h MO4 (Drive Programming output 4) R/W
1: ON
0: OFF
0043h MO5 (Drive Programming output 5) R/W
1: ON
0: OFF
Coil No. Item R/W Description
*1. When either the control circuit terminal block or the coil is turned on, these settings are ON.
The control circuit terminal block has the priority for the multi-function input terminals.
If the master cannot reset the coil ON status because of communication disconnection, turn the control
circuit terminal block from ON to OFF to turn off the coil.
*2. The communications error is retained until a fault reset is input. (Can be reset during operation.)
To Next Page
Loading...
