Omron 3G3RX - Page 300

4-181
4-4 Communication Function
4
Functions
001Ch Fault monitor 2 factor
d082R
See "Inverter Trip Factor List"
(page 4-183).

001Dh Fault monitor 2 Inverter status
See "Inverter Trip Factor List"
(page 4-183).

001Eh Fault monitor 2 frequency (HIGH)
0.00 to 400.00
0.01
[Hz]
001Fh Fault monitor 2 frequency (LOW)
0020h Fault monitor 2 current
Output current value at the time of
tripping
0.1 [A]
0021h Fault monitor 2 voltage DC input voltage at the time of tripping 1 [V]
0022h Fault
monitor 2 RUN time (HIGH)
Total RUN time before the trip 1 [h]
0023h Fault monitor 2 RUN time (LOW)
0024h Fault monitor 2 ON time (HIGH)
Total power ON time before the trip 1 [h]
0025h Fault monitor 2 ON time (LOW)
0026h Fault monitor 3 factor
d083R
See "Inverter Trip Factor List"
(page 4-183).

0027h Fault monitor 3 Inverter status
See "Inverter Trip Factor List"
(page 4-183).

0028h Fault monitor 3 frequency (HIGH)
0.00 to 400.00
0.01
[Hz]
0029h Fault monitor 3 frequency (LOW)
002Ah Fault monitor 3 current
Output current value at the time of
tripping
0.1 [A]
002Bh Fault monitor 3 voltage DC input voltage at the time of tripping 1 [V]
002Ch Fault monitor 3 RUN time (HIGH)
Total RUN time before the trip 1 [h]
002Dh Fault
monitor 3 RUN time (LOW)
002Eh Fault monitor 3 ON time (HIGH)
Total power ON time before the trip 1 [h]
002Fh Fault monitor 3 ON time (LOW)
0030h Fault monitor 4 factor
d084R
See "Inverter Trip Factor List"
(page 4-183).

0031h Fault monitor 4 Inverter status
See "Inverter Trip Factor List"
(page 4-183).

0032h Fault monitor 4 frequency (HIGH)
0.00 to 400.00
0.01
[Hz]
0033h Fault monitor 4 frequency (LOW)
0034h Fault monitor 4 current
Output current value at the time of
tripping
0.1 [A]
0035h Fault monitor 4 voltage DC input voltage at the time of tripping 1 [V]
0036h Fault
monitor 4 RUN time (HIGH)
Total RUN time before the trip 1 [h]
0037h Fault monitor 4 RUN time (LOW)
0038hFault monitor 4 ON time (HIGH)
Total power ON time before the trip 1 [h]
0039h Fault monitor 4 ON time (LOW)
Register
No.
Function name
Function
code
R/W Monitor and setting parameters Resolution
Note 1: The Inverter's rated current is "1000".
Note 2: If the set value is "10000" (100.0 sec) or more, the value in the second decimal place is ignored.