Omron 3G3RX - Page 301

4-182
4-4 Communication Function
4
Functions
003Ah Fault monitor 5 factor
d085R
See "Inverter Trip Factor List"
(page 4-183).

003Bh Fault monitor 5 Inverter status
See "Inverter Trip Factor List"
(page 4-183).

003Ch Fault monitor 5 frequency (HIGH)
0.00 to 400.00
0.01
[Hz]
003Dh Fault monitor 5 frequency (LOW)
003Eh Fault monitor 5 current
Output current value at the time of
tripping
0.1 [A]
003Fh Fault monitor 5 voltage DC input voltage at the time of tripping 1 [V]
0040h Fault
monitor 5 RUN time (HIGH)
Total RUN time before the trip 1 [h]
0041h Fault monitor 5 RUN time (LOW)
0042h Fault monitor 5 ON time (HIGH)
Total power ON time before the trip 1 [h]
0043h Fault monitor 5 ON time (LOW)
0044h Fault monitor 6 factor
d086R
See "Inverter Trip Factor List"
(page 4-183).

0045h Fault monitor 6 Inverter status
See "Inverter Trip Factor List"
(page 4-183).

0046h Fault monitor 6 frequency (HIGH)
0.00 to 400.00
0.01
[Hz]
0047h Fault monitor 6 frequency (LOW)
0048h Fault monitor 6 current
Output current value at the time of
tripping
0.1 [A]
0049h Fault monitor 6 voltage DC input voltage at the time of tripping 1 [V]
004Ah Fault monitor 6 RUN time (HIGH)
Total RUN time before the trip 1 [h]
004Bh Fault
monitor 6 RUN time (LOW)
004Ch Fault monitor 6 ON time (HIGH)
Total power ON time before the trip 1 [h]
004Dh Fault monitor 6 ON time (LOW)
004Eh Warning monitor d090 R
Warning code
0 to 385

004Fh
to
08FFh
Not used  
0900h EEPROM write  W
0000: Motor parameter recalculation
0001: Set value storage in EEPROM
Other: Motor parameter recalculation
and set value storage in
EEPROM

0901h
to
1000h
Not used  
1F01h Coil control word  R/W Register coil 0001h to 000Fh 
1E01h Coil status word  R Register coil 0010h to 001Fh 
Register
No.
Function name
Function
code
R/W Monitor and setting parameters Resolution
Note 1: The Inverter's rated current is "1000".
Note 2: If the set value is "10000" (100.0 sec) or more, the value in the second decimal place is ignored.