Section 10 Transferring Data 10-3 Data Transfer Using SPMA
NS-Designer Operation Manual
(1) Set the COM port to use to connect
the computer and PLC.
(2) Set the baud rate between the
computer and PLC.
(3) Set whether to detect the baud rate
between the computer and PLC.
(4) Input the response monitor time.
Increase the time only when there
are frequent communications error.
1 Port Set the COM port to use to connect the computer and PLC.
2 Baud rate Set the baud rate between the computer and PLC to 9600, 19200, 37400,
57600, or 115200.
3 Detect baud rate Set whether to detect the baud rate set for the peripheral port on the PLC.
The default is to detect the baud rate. If detection is disabled (pin 4 on the
PLC’s DIP switch is turned ON), set the baud rate in 2, above, to the same
speed as set for the peripheral port on the PLC.
4 Response monitor time Input the response monitor time. Increase the time only when there are
frequent communications error.
7. Set the Port to the COM port to use to connect the computer to the PLC. Here COM1 is set as and
example.
8. Click the OK Button in the Serial Setting Dialog Box.
9. Click the Set… Button on the right of the NS and PLC Field.
Enter the port to use to connect the PT
and PLC.
Enter the unit number of the destination
PT set for the NT Link (1:N).
10. Set the port to use to connect PLC and the unit number of the PT that will be the destination. Here,
the unit number is set to 0 because the cable is connected to the RS-232C port with a 1:1 con-
nection.
11. Click the OK Button in the Serial Setting Dialog Box.
12. Click the OK Button in the Comms Method Dialog Box.
Transferring Screen Data
1. Click the Connect Button in the Screen Data Transfer Dialog Box. After completing the connection,
the screen on the PT switches to the following screen and the PT will wait for the data to be trans-
ferred. Here, the entire project will be transferred as an example.
10-38
To Next Page
Loading...
