Section 10 Transferring Data 10-3 Data Transfer Using SPMA
NS-Designer Operation Manual
2. Check Select All, and click the button to display the Transfer Confirmation Dialog Box.
3. Click the Start Button. The download will be started.
4. The following dialog box will be displayed at the computer when the data transfer is finished. The
PT must be restarted to operate the screens that have been transferred. Click the YES Button to
restart the PT. Click the NO Button to continue downloading data.
Even if the NO Button is selected, the confirmation message shown below will be displayed when exit-
ing the Screen Data Transfer Dialog Box.
If the YES Button is clicked, the PT will be restarted. If the NO Button is clicked, it will become neces-
sary to restart the PT directly. To return to the Screen Data Transfer Dialog Box, click the Cancel But-
ton.
■ Serial Connection between a Computer and a PLC and Ethernet be-
tween a PLC and a PT Set for Transferring Data to the PT through the
PLC
This section describes an example of the settings used when transferring screen data from the
NS-Designer to a PT connected by Ethernet through a PLC connected with the computer by a serial
(toolbus) connection.
10-39
To Next Page
Loading...
