Omron NS - Page 276

Section 10 Transferring Data 10-3 Data Transfer Using SPMA
NS-Designer Operation Manual
Ethernet
Serial (Toolbus)
Ethernet Settings
Ethernet Unit Setting
Screen Data
Node Address 6
IP Address 192.168.0.6
Unit Number 1
Node Address 22
IP Address 192.168.0.22
Ethernet network
address
3
Settings on the PLC
Create the following routing table entry using CX-Net of CX-Programmer Ver. 3.1 or later and transfer
the routing tables to the PLC.
1. Input the unit number of the Ethernet Unit. Here, 1 is input.
2. Input the network address of the Ethernet Unit. Here, 3 is input.
Reference
♦
Turn OFF pin 5 on the DIP switch on the PLC’s CPU Unit when connecting a device other than a
computer running the CX-Programmer (such as a PT or host computer).
♦
Turn ON pin 5 when connecting a computer running the CX-Programmer.
R
R
e
e
f
f
e
e
r
r
e
e
n
n
c
c
e
e
10-40