111
Parts Section 7-2
7-2-7 Changing the Size of a Part
The following methods can be used.
When you select a part, a selection border is displayed.
Use the mouse to drag the part handles to the desired size.
To adjust the size of a part without affecting its aspect ratio, hold down the
Shift Key while dragging the part to the desired size.
For a part containing text, however, the smallest possible size is limited by the
size of the text.
If the size of the character string is made larger than the standard size, the
part is automatically enlarged.
Character size: 16 dots Character size: 48 dots
The part cannot be made any smaller.
To Next Page
Loading...
