197
Transferring Screens from the NV-Designer Section 9-1
Direction
Transfer Data after Clear NV Screen
Select this check box to transfer data to the PT after deleting all previously
transferred data. When this check box is not selected, the NV-Designer will
delete the screen data, but any transferred data will not be deleted from the
PT.
Update the Firmware Automatically
When transfer of all of the data is selected, the new firmware for the PT can
be transferred at the same time. When the PT firmware is the same as the file
installed on the NV-Designer, automatic update is not performed.
Verify Select this check box to verify the data after the data from the NV-Designer
has been written to the PT. Verification involves checking whether the screens
transferred to the PT have been transferred correctly after all data has been
transferred to the PT.
9-1-3 Executing the Transfer
1,2,3... 1. If there is already screen data in the PT when you click the OK Button to
transfer screen data, the following dialog box will be displayed.
2. Click the Yes or All Button to execute the transfer.
9-1-4 Setting Passwords
Passwords can be set in the PT. You can protect the screen data that you
have created by setting a password that will prevent uploading and download-
ing screen data unless the correct password is entered.
NV-Designer → PT The data that was selected for transfer will be written from the
NV-Designer to the PT.
PT → NV-Designer The data that was selected for transfer will be written from the
PT to the NV-Designer.
See Also
Refer to 8-6 Security Functions.
To Next Page
Loading...
