Omron NV Series - Transferring Screens from the NV-Designer

194
Transferring Screens from the NV-Designer Section 9-1
9-1 Transferring Screens from the NV-Designer
Base screen data and NV Configuration data can be transferred from the NV-
Designer to the PT. You can transfer the base screens, NV Configurations,
keyboard screens, flow display data, write address data, recipe files, and
passwords. The data is stored in flash memory in the PT.
■ NV3W
■ NV4W/NV3Q
NV3W
Power supply (5 V or 24 V)
Not required for XW2Z-200T-4 (2 m with 5-V line).
NV-Designer
Screen Design
Software
Base screen data, NV
Configuration, and other data
is transferred.
Programming Device Connecting Cable
(RS-232C cable with a round DIN pin
connector for the NV3W)
NV-TOL-3M
NV4W/NV3Q
Commercially available USB cable
Power supply (24 V)
NV4W: Mini B Type
NV3Q: B Type
NV-Designer Screen
Design Software
Base screen data, NV Configuration,
and other data is transferred.
See Also
Refer to the following section for details on connecting the PT and PLC:
Section 6 Connecting the PLC in the Setup Manual.