Omron NV Series - 7-12 Custom Parts; 7-12-1 Creating a Switch Part

156
Custom Parts Section 7-12
7-12 Custom Parts
Custom parts allow you to edit part screens to create original parts. There are
three types of custom parts: bit switches, lamps, and messages.
7-12-1 Creating a Switch Part
1,2,3... 1. Open base screen 0 and position a custom switch part.
2. Double-click the custom switch part and make the settings.
The settings made with each tab page are as follows.
1. Replacement
If On is set, the display can be switched according to the contents of the
PLC memory. There are three setting methods.
ON/OFF: The display is switched when a bit turns ON and OFF.
Click "0" in the Screen Man-
ager, and then drag the cus-
tom switch part (SW
(Custom)) and drop it on the
base screen.
Drag a SW (Custom) part
from the Standard Parts
Library, double-click the part,
and then set the switch
attributes.