157
Custom Parts Section 7-12
Digit: The display is switched to a hexadecimal (0 to F) display accord-
ing to one digit (4 bits)
Direct: The display is switched using 1-word units.
2. Operation
Make the desired settings, such as SET or RESET.
3. Option
The switch operation sound and reversing when touched can be set.
Note For Momentary, the display is reversed while the switch is held
down.
4. Valid Condition
Status in PLC memory can be used to enable and disable switch operation.
5. Reverse/Blink
The display method can be set.
3. To change the character string or graphic displayed on a custom switch,
place the switch in Edit Mode.
Right-click the switch part and
select Edit.
To Next Page
Loading...
