200
Transferring and Copying Data Using SD Memory Cards (NV4W/NV3Q) Section 9-2
• When the SD memory card is subjected to static electricity or electrical
noise
• When the SD memory card is removed, or the power is turned OFF while
the card is being accessed, such as when data is being saved or deleted
Note (1) OMRON recommends saving important data to other media, and always
having a backup.
(2) Do not pull out the SD memory card or turn OFF the power while the SD
memory card access indicator is lit on the PT. (This indicator light while
data is being read from or written to the card.) Data may be destroyed.
9-2-4 Storing Data on an SD Memory Card
1,2,3...
9-2-5 Reading Data from an SD Memory Card
1,2,3...
9-2-6 Formatting an SD Memory Card
SD memory cards are shipped pre-formatted from the factory, so there is nor-
mally no need to format them.
1. Select Transfer - Cre-
ate SD Memory Card
File from the PT Menu
of NV-Designer.
2. Select the SD memory
card drive, and then
enter a name for the file
to be saved.
To overwrite a file, click
the name of the exist-
ing file.
3. Click the OK Button to
save the data to the SD
memory card.
1. Select Transfer - Read
from SD Memory Card
File from the PT Menu
of NV-Designer.
2. Select the SD memory
card drive.
3. Select the file to read
and click the OK But-
ton. The screen data
from the selected file
will be displayed by NV-
Designer.
To Next Page
Loading...
