72
Setting the NV Configuration from the NV-Designer Section 6-2
6-2 Setting the NV Configuration from the NV-Designer
This section describes the procedure for setting the NV Configuration from the
NV-Designer. Refer to the Setup Manual for information on how to set the NV
Configuration from the System Menu.
6-2-1 Setting Method
1,2,3... 1. Select PT – NV Configuration from the NV-Designer Menu to open the NV
Configuration Dialog Box. If multiple project files are already open, the Se-
lect File Dialog Box will be displayed. Select a project file to set up.
2. Set the required items. (Refer to 6-2-2 Basic Settings Tab Page and follow-
ing sections for details.)
3. Save the file and transfer it to the PT. (Refer to 9-1 Transferring Screens
from the NV-Designer for details.)
Note The settings will be reflected in the PT once the setting file has been trans-
ferred from the NV-Designer.
To Next Page
Loading...
