127
Data Parts and Keyboard Parts Section 7-7
7. Enter text and frames into the data and keyboard parts.
8. Transfer the screen to the PT.
9. Check the display on the PT.
After making the above set-
tings, enter “Update data
Change” on DA0 on the base
screen.
Next to KY0 on keyboard
screen 0, enter the text “Input
data” and then place a frame
around the text.
When data has been trans-
ferred, the parts created on
the NV-Designer will be dis-
played on the PT screen.
Touch the data part on the
panel to switch to the Input
data screen.
Enter a value, then touch the
ENT Key to return to the
Update data screen.
To Next Page
Loading...
