172
Write Address Data Section 8-4
4. Enable Condition 1 and click the Conditions Button. The Conditions Dialog
Box will be displayed.
5. Click the Operation Tab and make the following settings.
6. Click the OK Button to return to the Write Address Dialog Box. To write mul-
tiple conditions or data, select row No. 0 from the list and click the Settings
Button.
7. Click the OK Button to return to the base screen and transfer the file.
Make the following settings.
Address Type:
Relation Code:
Address:
Bit
Address: ON
10.00
Operation
Mode
Others
Add (DEC/1W)
Output
Device to
Add/Sub:
D100
D100
1
Note Up to 100 settings can
be registered.
Additional Information
• If All Screens is selected multiple times in the condition settings, the PT will be
reading PLC data multiple times, slowing the response. If the screen can be
specified, it is recommended to use the Specified Screen Options.
• The Write Address function is perform only once when the specified conditions
are met. The operation is performed only once each time when the conditions
are met. It is performed again until status changes.
To Next Page
Loading...
