179
Recipes Section 8-5
1,2,3... 1. Select Write Address from the PT Menu.
2. Click the Condition Tab and set the conditions.
3. Set the operation mode.
Condition: Write Completed Flag
W20.08 is ON
Specified Screen:
Condition 1:
Address type:
Relation code:
Address:
Condition 2:
All Screens
Operational
under Valid
Condition
Bit
Address: ON
W20.08
Always
Operational
Note Specify the screen number
if the screen needs to be
specified.
Operation: Turn OFF the Write
Bit (W20.00)
Operation Mode: RESET
W20.00
Precaution for Correct Operation
Up to 100 addresses can be written. The PT constantly reads the conditional
addresses registered for the write address function to the PLC. As the number of
registered addresses increase, the response of the PT to change or update the
display will become slow.
To Next Page
Loading...
