47
Creating a Simple Screen Section 4-2
3. Double-click the part that was pasted and specify “D100” on the Basic Set-
up Tab Page as the communications address in the PLC.
Setting Lamps
Use the following procedure to create a lamp that will display the status of a
bit in the PLC on screen 1.
1,2,3... 1. Select the lamp parts library.
2. Drag the part called Lamp0 and drop it on the base screen.
3. Double-click the part that was pasted and specify “W100.00” on the Basic
Setup Tab Page as the communications address in the PLC.
Setting Function Switches
Use the following procedure to create a function switch (labeled "Return") to
switch the screen to the previously displayed screen (screen 0).
1,2,3... 1. Select the function switch parts library.
2. Drag the part called FSW0 and drop it on the base screen.
3. Double-click the function switch that was pasted.
To Next Page
Loading...
