Remove the System Configuration PROM
118 SPARC T5-8 Server Service Manual • November 2015
Remove the System Configuration PROM
The system configuration PROM is a cold-service component that can be replaced only by
qualified service personnel.
Before beginning this procedure, ensure that you are familiar with the cautions and safety
instructions described in “Safety Information” on page 49. For the location of the system
configuration PROM, see “Main Module Internal Component Locations” on page 17.
Caution - This procedure involves handling circuit boards that are extremely sensitive to static
electricity. Ensure that you follow ESD preventative practices to avoid damaging the circuit
boards.
1.
Remove the main module from the server.
See “Remove the Main Module” on page 91.
2.
Take the necessary ESD precautions.
See “Prevent ESD Damage” on page 57.
3.
Locate the system configuration PROM on the main module.
See “Main Module Internal Component Locations” on page 17.
4.
Grasp the system configuration PROM, and lift it up to remove it from the main
module.
To Next Page
Loading...
Need help?
General