Configure POST
Detecting and Managing Faults 39
Configure POST
1.
Log in to Oracle ILOM.
See “Log In to Oracle ILOM (Service)” on page 28.
2.
Set the virtual keyswitch to the value that corresponds to the POST
configuration you want to run.
This example sets the virtual keyswitch to normal, which configures POST to run according to
other parameter values.
-> set /HOST keyswitch_state=normal
Set 'keyswitch_state' to 'Normal'
For possible values for the keyswitch_state parameter, see “Oracle ILOM Properties That
Affect POST Behavior” on page 35.
3.
If the virtual keyswitch is set to normal, and you want to define the mode, level,
verbosity, or trigger, set the respective parameters.
Syntax:
set /HOST/diag property=value.
See “Oracle ILOM Properties That Affect POST Behavior” on page 35 for a list of
parameters and values.
Examples:
-> set /HOST/diag mode=normal
-> set /HOST/diag verbosity=max
4.
View the current values for settings.
Example:
-> show /HOST/diag
/HOST/diag
Targets:
Properties:
error_reset_level = max
error_reset_verbosity = normal
hw_change_level = max
hw_change_verbosity = normal
level = min
mode = normal
power_on_level = max
power_on_verbosity = normal
trigger = hw_change error-reset
verbosity = normal
To Next Page
Need help?
General