Oracle SPARC T5-8 - Servicing the Front I;O Assembly; Remove the Front I;O Assembly

Servicing the Front I/O Assembly 127
Servicing the Front I/O Assembly
The front I/O assembly is a cold-service component that can be replaced only after you have
removed the main module.
Caution - This procedure requires that you handle components that are sensitive to electrostatic
discharge. This discharge can cause server components to fail.
These topics describe service procedures for the front I/O assembly in the server.
Steps Description Links
1. Remove the main module so that you can replace the
front I/O assembly.
“Remove the Main Module” on page 91
2. Replace the I/O assembly. ■ “Remove the Front I/O
Assembly” on page 127
■ “Install the Front I/O
Assembly” on page 130
3. Install the main module after you have replaced the
I/O assembly.
“Install the Main Module” on page 95
4. Verify the installation. “Verify the Front I/O Assembly” on page 131
Related Information
■
“Identifying Components”
■
“Detecting and Managing Faults”
■
“Preparing for Service”
■
“Component Service Task Reference” on page 23
■
“Returning the Server to Operation”
Remove the Front I/O Assembly
The front I/O assembly is a cold-service component that can be replaced only after you have
removed the main module.