Servicing Processor Modules 59
Servicing Processor Modules
The SPARC T5-8 server supports two configurations:
■
Fully-populated — four processor modules
■
Half-populated — two processor modules and two processor filler modules
Processor modules and processor filler modules are cold-service components that can be
replaced only after you remove all power from the system. For the location of the processor
modules, see “Front Panel Components (Service)” on page 14.
Caution - This procedure requires that you handle components that are sensitive to electrostatic
discharge. This discharge can cause server components to fail.
These topics describe how to service the processor modules:
■
“Server Upgrade Process” on page 59
■
“Processor Module LEDs” on page 61
■
“Determine Which Processor Module Is Faulty” on page 62
■
“Remove a Processor Module or Processor Filler Module” on page 63
■
“Install a Processor Module or Processor Filler Module” on page 67
■
“Verify the Processor Module” on page 70
Related Information
■
“Identifying Components”
■
“Detecting and Managing Faults”
■
“Preparing for Service”
■
“Component Service Task Reference” on page 23
■
“Returning the Server to Operation”
Server Upgrade Process
The SPARC T5-8 server supports two configurations:
To Next Page
Loading...
Need help?
General