Oracle SPARC T5-8 - Verify the Power Supply

Verify the Power Supply
138 SPARC T5-8 Server Service Manual • November 2015
3.
Press the lever against the power supply to fully seat the power supply in the
server.
4.
Verify the installation.
See “Verify the Power Supply” on page 138.
Related Information
■
“Remove a Power Supply” on page 135
■
“Verify the Power Supply” on page 138
Verify the Power Supply
1.
Verify that the power supply Power OK and AC Present LEDs are lit and that the
Fault LED is not lit.
See “Rear Panel Controls and LEDs” on page 33.
2.
Verify that the front and rear Service Required LEDs are not lit.
See “Interpreting LEDs” on page 29.
3.
Log in to Oracle ILOM.
See “Log In to Oracle ILOM (Service)” on page 28.