Verify the Power Supply
Servicing Power Supplies 139
4.
Start the faultmgmt shell.
-> start SP/faultmgmt/shell
Are you sure you want to start the faultmgmt shell (y/n)? y
faultmgmtsp>
5.
Use the fmadm faulty command to determine if the server is operating normally.
■
If a fault was detected, see “Diagnostics Process” on page 25.
■
If no fault was detected, the power supply was installed successfully.
Related Information
■
“Determine Which Power Supply Is Faulty” on page 134
■
“Install a Power Supply” on page 137
To Next Page
Loading...
Need help?
General