Clear a Fault
44 SPARC T5-8 Server Service Manual • November 2015
Clear a Fault
When PSH detects faults, the faults are logged and displayed on the console. In most cases,
after the fault is repaired, the corrected state is detected by the server, and the fault condition
is repaired automatically. However, this repair should be verified. In cases where the fault
condition is not automatically cleared, you must clear the fault manually.
1.
After replacing a faulty FRU, power on the server.
See “Returning the Server to Operation”.
2.
At the host prompt, determine whether the replaced FRU still shows a faulty
state.
See “Check for Faults” on page 41.
■
If no fault is reported, you do not need to do anything else. Do not perform
the subsequent steps.
■
If a fault is reported, continue to Step 3.
3.
Clear the fault from all persistent fault records.
In some cases, even though the fault is cleared, some persistent fault information remains
and results in erroneous fault messages at boot time. To ensure that these messages are not
displayed, type this PSH command:
faultmgmtsp> fmadm acquit UUID
4.
If required, reset the server.
In some cases, the output of the fmadm faulty command might include this message for the
faulty component:
faulted and taken out of service.
If this message appears in the output, you must reset the server after you manually repair the
fault.
faultmgmtsp> exit
-> reset /System
Are you sure you want to reset /System? y
Resetting /System ...
5.
Clear the fault in the Oracle Enterprise Manager Ops Center software, if
applicable.
Clearing a fault with the fmadm aquit command does not clear that fault in the Oracle
Enterprise Manager Ops Center software. You must manually clear the fault (that is, incident).
For more information, see 9.9.10 Marking an Incident Repaired in the Oracle Enterprise
Manager Ops Center Feature Reference Guide at:
To Next Page
Loading...
Need help?
General