Servicing the Rear Chassis Subassembly 181
Servicing the Rear Chassis Subassembly
The rear chassis subassembly is a cold-service component that can be replaced only by qualified
service personnel. You must remove all of the power from the server before you attempt to
remove the rear chassis subassembly. For the location of the rear chassis subassembly, see
“Rear Panel Components (Service)” on page 15.
Caution - This procedure requires that you handle components that are sensitive to electrostatic
discharge. This discharge can cause server components to fail.
These topics describe service procedures for the rear chassis subassembly in the server.
Steps Description Links
1. Determine if the rear chassis subassembly is faulty
using the system software.
“Determine if the Rear Chassis Subassembly Is
Faulty” on page 181
2. If the rear chassis subassembly is faulty, shut the
server down.
“Removing Power From the Server” on page 53
3. Remove the rear chassis subassembly. “Remove the Rear Chassis
Subassembly” on page 182
4. Install the rear chassis subassembly. “Install the Rear Chassis
Subassembly” on page 185
5. Return the server to operation. “Returning the Server to Operation”
6. Verify the installation. “Verify the Rear Chassis
Subassembly” on page 188
Related Information
■
“Identifying Components”
■
“Detecting and Managing Faults”
■
“Preparing for Service”
■
“Component Service Task Reference” on page 23
■
“Returning the Server to Operation”
Determine if the Rear Chassis Subassembly Is Faulty
1.
Log in to Oracle ILOM.
To Next Page
Loading...
Need help?
General