Verify the Main Module
98 SPARC T5-8 Server Service Manual • November 2015
Are you sure you want to start the faultmgmt shell (y/n)? y
faultmgmtsp>
3.
Use the fmadm faulty command to determine if the server is operating normally.
■
If a fault was detected, see “Diagnostics Process” on page 25.
■
If no fault was detected, the main module was installed successfully.
Related Information
■
“Determine if the Main Module Is Faulty” on page 91
■
“Install the Main Module” on page 95
To Next Page
Loading...
