Shutting down interface p1p2: [ OK ]
Shutting down loopback interface: [ OK ]
Bringing up loopback interface: [ OK ]
Bringing up interface em1: [ OK ]
Bringing up interface em2: Determining if ip address 10.1.10.2 is already
in use for device em2...
[ OK ]
Bringing up interface em3: [ OK ]
Bringing up interface p1p1: Determining if ip address 192.0.2.24 is
already in use for device p1p1...
[ OK ]
Bringing up interface p1p2: Determining if ip address 192.0.2.25 is
already in use for device p1p2...
[ OK ]
odacli Apply Patch and Update Commands
Use the commands
odacli update
and
apply patch
to apply patches and update the
appliance.
• odacli describe-component
Use the odacli describe-component command to display the installed
version and the latest available version for each component.
• odacli describe-latestpatch
Use the odacli describe-latestpatch command to display a list of the
latest supported patch versions for each component.
• odacli create-prepatchreport
Use the odacli create-prepatchreport command to run pre-checks for
patching.
• odacli describe-prepatchreport
Use the odacli describe-prepatchreport command to display the pre-
check report, with a list of pre-checks run with status and comments.
• odacli update-agentconfig-parameters
Use the odacli update-agentconfig-parameters command to modify
configuration variables used by the appliance.
• odacli list-agentconfig-parameters
Use the odacli list-agentconfig-parameters command to list
configuration variables used by the appliance.
• odacli list-availablepatches
Use the odacli list-availablepatches command to display all available
patches for Oracle Database Appliance.
• odacli list-prepatchreports
Use the odacli list-prepatchreports command to display all pre-check
reports, with a list of pre-checks run with status and comments.
• odacli delete-prepatchreport
Use the odacli delete-prepatchreport command to delete any pre-check
report.
Chapter 13
odacli Apply Patch and Update Commands
13-10
To Next Page
Loading...
Need help?
General