oakcli show version
Use the
oakcli show version
command to display the applied patch versions for
Oracle Database Appliance software and firmware.
Syntax
oakcli show version [-detail] [-h]
Parameter Description
-detail
(Optional) Display detailed version information.
-h
(Optional) Display help for using the command.
Usage Notes
When you apply the patch and then run the command
oakcli show version -detail
,
the output shows the installed version and that the supported versions are
Up-to-date
for each component. If you unpack the patch bundle (
oakcli unpack -pack
) and then
run the command
oakcli show version -detail
before applying the patch, the
output shows
No-update
in the Supported Version column.
Note:
After unpacking the patch bundle, but before applying the patch, use the
oakcli update -patch version --verify
command to verify the contents
of the patch instead of issuing
oakcli show version -detail
.
Displaying the Oracle Database Appliance Version
This is an example of how to determine if all of the components are successfully
updated after applying the 12.1.2.10.0 patch. You can also view the applied patch
version information for the software and firmware on Oracle Database Appliance. All
components are successfully updated when
Up-to-date
appears in the Supported
Version column.
# oakcli show version -detail
Mon Feb 13 03:31:48 PST 2017
Reading the metadata. It takes a while...
System Version Component Name Installed Version Supported Version
-------------- --------------- ------------------ -----------------
12.1.2.10.0
Controller_INT 4.230.40-3739 Up-to-date
Controller_EXT 09.00.00.00 Up-to-date
Expander 0291 Up-to-date
SSD_SHARED {
[ c2d20,c2d21,c2d22, A29A Up-to-date
c2d23 ]
[ c2d0,c2d1,c2d2,c2d A29A Up-to-date
Chapter 14
oakcli show commands
14-50
To Next Page
Loading...
Need help?
General