Task Command to Run on the
DCS Stack
Command to Run on the
OAK Stack
Show the storage controllers,
expanders, and disks.
odaadmcli show storage oakcli show storage
Run diagnostic tests on a disk
in the storage shelf or storage
expansion shelf and collect
detailed information for each
disk or NVMe.
odaadmcli stordiag oakcli stordiag
Collect diagnostic logs for
storage components.
odaadmcli manage
diagcollect
oakcli manage
diagcollect
Power a disk on or off.
odaadmcli power disk
Add a local disk to the system
after physically replacing a
failed disk.
oakcli add disk -local
Locate disks with write cache
enabled and to disable disk
write cache for those disks.
Not Applicable
oakcli diskwritecache
Display information about the
storage enclosure subsystem
on the node where the
command is executed.
odaadmcli show
enclosure
oakcli show enclosure
Configure solid-state drives
(SSDs) for data storage into
the existing base configuration
to fully populate the base
storage shelf.
Not Applicable
oakcli expand storage
Display internal RAID and
local disk information. Not
applicable for X7-2 models.
odaadmcli show iraid oakcli show iraid
Locate the physical disk that is
associated with a named
Oracle ASM disk by turning
the disk's LED light on or off.
Not Applicable
oakcli locate disk
Display information about a
SAS expander.
odaadmcli show expander oakcli show expander
Show whether validation
storage is enabled or disabled.
odaadmcli show
validation storage
oakcli show validation
storage
Show hard storage errors,
such as the wrong type of disk
inserted into a particular slot,
an invalid disk model, or an
incorrect disk size.
odaadmcli show
validation storage
errors
oakcli show validation
storage errors
Show soft validation errors,
such as an invalid version of
the disk firmware.
odaadmcli show
validation storage
failures
oakcli show validation
storage failures
Job Commands
ODACLI and OAKCLI commands for managing jobs.
Appendix A
Job Commands
A-6
To Next Page
Loading...
Need help?
General