odacli validate-storagetopology
Use the
odacli validate-storagetopology
command to check the cable connections
between the system controllers and the storage shelf, as well as the cable connection
to the storage expansion shelf (if one is installed).
Oracle recommends that you run the
odacli validate-storagetopology
command
before deploying the system to ensure that the cabling is correct. This will avoid and
prevent problems during deployment due to incorrect or missing cable connections. If
the cabling is not correct, you will see errors in your output.
File Path
$ORACLE_HOME/opt/oracle/dcs/bin/odacli
Syntax
odacli validate-storagetopology [–h]
Parameters
Parameter Description
--help
,
-h
(Optional) Displays help for using the command.
odaadmcli Hardware Monitoring Commands
Use the
hardware monitoring
commands to display hardware configurations.
• odaadmcli show cooling
Use the odaadmcli show cooling command to show cooling details.
• odaadmcli show env_hw
Use the odaadmcli show env_hw command to display information about the
environment and hardware.
• odaadmcli show fs
Use the odaadmcli show fs command to display filesystem details.
• odaadmcli show memory
Use the odaadmcli show memory command to display memory details.
• odaadmcli show network
Use the odaadmcli show network command to show network details.
• odaadmcli show power
Use the odaadmcli show power command to display power supply details.
• odaadmcli show processor
Use the odaadmcli show processor command to display processor details.
• odaadmcli show server
Use the odaadmcli show server command to display server details.
Chapter 13
odacli validate-storagetopology
13-111
To Next Page
Loading...
Need help?
General