Running ORAchk on Oracle Database Appliance 18.3 Baremetal Systems for
New Installation
When you install Oracle Database Appliance 18.3, the ORAchk RPMs are installed in
the directory /opt/oracle.SupportTools/orachk/. You can verify that ORAchk
is installed by running the following command:
[root@oak bin]# rpm -q orachk
orachk-18.3.0_20180808-2.x86_64
Run orachk as follows:
[root@oak bin]# orachk
This computer is for [S]ingle instance database or part of a [C]luster to
run
RAC database [S|C] [C]: S
orachk did not find the inventory location on oak from environment. Does
oak
have Oracle software installed [y/n][n]? n
...
Detailed report (html) -
/opt/oracle.SupportTools/orachk/orachk_oak_091918_182425/
orachk_oak_091918_182
425.html
UPLOAD [if required] -
/opt/oracle.SupportTools/orachk/orachk_oak_091918_182425.zip
Running orachk on Oracle Database Appliance Baremetal Systems for Releases
Earlier than 18.3
1. Open the command-line interface as
root
.
2. Navigate to the ORAchk tool in the
/suptools
directory.
/u01/app/12.2.0.1/grid/suptools/orachk
3. Run the utility.
./orachk
When all checks are finished, a detailed report is available. The output displays
the location of the report in an HTML format and the location of a zip file if you
want to upload the report.
4. Review the Oracle Database Appliance Assessment Report and system health
and troubleshoot any issues that are identified.
The report includes a summary and filters that enable you to focus on specific
areas. For example, you can choose the filter to show failed checks only, show
checks with a Fail, Warning, Info, or Pass status, or any combination.
Chapter 15
Using the Oracle ORAchk Health Check Tool
15-7
To Next Page
Loading...
