Panasonic MN103S

Chapter 1
Overview
Electrical Characteristics I - 17
1.5 Electrical Characteristics
This LSI manual describes the standard specification.
Electrical characteristics given in this section are preliminary and subject to change without notice. When using
LSI, contact our sales office for product specifications.
1.5.1 Absolute Maximum Ratings
Model CMOS LSI
Application
General-purpose
Function CMOS 32-bit 1 chip microcontroller
V
SS
=0.0 V
Parameter Symbol Rating Unit
A1 External supply voltage V
DD
-0.3 to +7.0 V
A2 Internal supply voltage V
DD2
-0.3 to +2.5 V V
A3 Flash EEPROM supply voltage V
DD3
-0.3 to +4.6 V V
A4 Input pin voltage V
I
-0.3 to VDD +0.3 (upper limit: 7.0) V
A5 I/O pin voltage V
IO
-0.3 to VDD +0.3 (upper limit: 7.0) V
A6 Peak output current IOPEAK ±10 mA
A7 Typ. range output current IOAVG ±5 mA
A8
Operating ambient temperature
TOPR -40 to +85 °C
A9 Storage temperature TSTG -40 to +125 °C
A10 Power dissipation PD 600 mW
Note:
Each of the absolute maximum ratings refers to limits or values that will not damage the chip even if the chip is subject to that rat-
ing. The average output current rating is applicable to any given 100-ms period. The total of the average output current of all pins
should be less than 50mA. Insert at least one 10 µF or higher bypass capacitor between each power supply pins (VDD pins) and
ground. Additionally, insert at least one 1 µF or higher bypass capacitor between internal each power supply pins (V
DD2
pins) and
ground.
Additionally, insert at least one 2µF or higher bypass capacitor between Flash EEPROM power supply pins (V
DD3
pins) and
ground.
It is recommended that total capacitance between all of the VDD and VSS is more than 10-times sum of capacitance between all
of the VDD2 and VSS plus capacitance etween VDD3 and VSS.