Panasonic MN103S

Chapter 1
Overview
Electrical Characteristics I - 21
V
DD
= 5.0 V
V
SS
= 0.0 V
Ta= -40 °C to +85 °C
Parameter Symbol Conditions
Limits
Unit
Min. Typ. Max.
Input pins
< input: CMOS level>
NRST, TEST1 to TEST3
C8 Input voltage High level
V
IH2
-V
DD
x 0.8 - V
DD
V
C9 Input voltage Low level
V
IL2
-0.0-V
DD
x 0.2 V
C10 Input current Low level
I
IH2
V
IN
=0 V
Pull-up resistor is always con-
nected
-55 -166 -500 µA
How to use test pins
The following pins are for LSI test. These pins are incorporated pull-up resistor.
TEST1 (P24) ... Pull-up to VDD with OPEN or about 1 kΩ resistor.
TEST2 (P25) ... Pull-up to VDD with OPEN or about 1 kΩ resistor.
TEST3 (P26) ... Pull-up to VDD with OPEN or about 1 kΩ resistor.
V
DD
=5.0 V
V
SS
= 0.0 V
Ta= -40 °C to +85 °C
Parameter Symbol Conditions
Limits
Unit
Min. Typ. Max.
OSCI pin
C11 Input voltage High level V
IH4
When external clock is input V
DD
x 0.9 - V
DD
V
C12 Input current Low level V
IL4
When external clock is input 0.0 - V
DD
x 0.1 V
C13 Internal feedback resistor R
FB
V
1
= V
DD
or V
SS
-1.0- MΩ
Regulator output pin V
DD2
, V
DD3
*1
*1.Use the regulator output as power supply only for the microcontroller
C14 Output voltage range V
DD2
-1.651.81.95V
C15 Output voltage range V
DD3
- 3.0 3.3 3.6 V