Philips LPC2101 - Copy RAM to Flash; Count_Error

© Koninklijke Philips Electronics N.V. 2006. All rights reserved.
User manual Rev. 01 — 12 January 2006 245
Philips Semiconductors
UM10161
Volume 1 Chapter 19: Flash memory
19.9.2 Copy RAM to flash
Return Code CMD_SUCCESS |
BUSY |
INVALID_SECTOR
Result None
Description This command must be executed before executing "Copy RAM to Flash" or "Erase
Sector(s)" command. Successful execution of the "Copy RAM to Flash" or "Erase
Sector(s)" command causes relevant sectors to be protected again. The boot
sector can not be prepared by this command. To prepare a single sector use the
same "Start" and "End" sector numbers.
Table 227: IAP Prepare sector(s) for write operation command
Command Prepare sector(s) for write operation
Table 228: IAP Copy RAM to flash command
Command Copy RAM to Flash
Input Command code: 51
10
Param0(DST): Destination Flash address where data bytes are to be written. This
address should be a 256 byte boundary.
Param1(SRC): Source RAM address from which data bytes are to be read. This
address should be a word boundary.
Param2: Number of bytes to be written. Should be 256 | 512 | 1024 | 4096.
Param3: System Clock Frequency (CCLK) in kHz.
Return Code CMD_SUCCESS |
SRC_ADDR_ERROR (Address not a word boundary) |
DST_ADDR_ERROR (Address not on correct boundary) |
SRC_ADDR_NOT_MAPPED |
DST_ADDR_NOT_MAPPED |
COUNT_ERROR (Byte count is not 256 | 512 | 1024 | 4096) |
SECTOR_NOT_PREPARED_FOR_WRITE_OPERATION |
BUSY |
Result None
Description This command is used to program the flash memory. The affected sectors should
be prepared first by calling "Prepare Sector for Write Operation" command. The
affected sectors are automatically protected again once the copy command is
successfully executed. The boot sector can not be written by this command.